This Modified Sine Wave Inverter frequency rate is 50Hz, give you 240V AC output. Powered by the 2 pieces of power MOSFETs STP55NF06L, the inverter capable to deliver up to 500W power. The PIC16F628A is programmed to produce a logic 5v signal for 5ms at pin 17 then 15ms off. Then the same at pin 18, 5ms on then 15ms off (4.17ms for 60Hz). That is one cycle which is then looped.
The MOSFET’s could be in parallel pairs for even more power. Just give each its own 470Ω gate resistor and a 22kΩ from each gate to source. The large 1000µF capacitor and 47Ω resistor used to clean up the voltage spikes coming from the transformer centre tap into the positive rail and protect the PIC from them.
If you want to know the complete project for this 500W Modified Sine Wave Inverter, just come to visit this page
1) My input Supply will be 42VDC to 60VDC, what will be the value of Resister in place of 47 ohms ?
2) What will be the Transformer size for 1KVA ?
3) What will be filter Capaciter value atSine wave Output?
PLS let the diagram & its labels be clear. I could not read the values of the components in the circuit diagram
go here:
http://m0ukd.com/static/homebrew/modified_sine_wave_inverter/500w_PIC_Modified_Sine_Wave_Inverter_Large.jpg